ANVEO keeps adding digimap items to my OBI200

<< < (3/3)

Taoman:
Anveo web portal.

IP Phone/ATA Device: How to connect -> Sip Registration Details

I seem to remember that Anveo OBitalk subscribers could not see their SIP credentials which means you couldn't make a Voice Gateway.

azrobert:
Most people don't understand that the ITSP DigitMaps are only used when referenced by another rule. They are only automatically used in Trunk Groups, so the following suggestion will not work with TGs. You can just ignore the ITSP DigitMap and use a User Defined DigitMap.

I see by your previous posts that GV is used for USA and Anveo for Canada. The following example assumes Anveo is on your Primary line. I don't know if you added any rules to the Phone OutboundCallRoute to route calls to GV.

"(Mpli)" points to the Primary Line's DigitMap and "pli" points to the Primary Line.

Setup a User Defined DigitMap:
User Settings -> User Defined Digit Maps -> Digit Map2
Label: ud1
DigitMap: (Your_Anveo_Rules)

Physical Interfaces -> Phone1 Port

The last rule in the DigitMap is (Mpli)
Change it to (Mud1)

The last rule in the OutboundCallRoute is {(Mpli):pli}
Change it to {(Mud1):pli}

Now your OBi will ignore the ITSP DigitMap and use the User DigitMap.

sylvaing:
Thanks, I'll give it a try.

Question, which other rule references the ITSP DigitMaps normally?

azrobert:
The only default rules that refer to the ITSP DigitMaps are the rules for the **x prefixes. These can be found in the Phone and Auto Attendant DigitMaps and OutboundCallRoutes. Examples are "**2(Msp2)" in DigitMaps and "{(<**2:>(Msp2)):sp2}" in OutboundCallRoutes.

Any DigitMap, InboundCallRoute or OutboundCallRoute can be modified to refer back to any DigitMap.

An example is routing international numbers to SP2 without a prefix:
ITSP B DigitMap: (011xx.)
Add (Msp2) to the Phone DigitMap
Add {(Msp2):sp2} to the beginning of the Phone OutboundCallRoute

Navigation

[0] Message Index

[*] Previous page