obi100 suddenly SOMETIMES incoming calls goes VM directly, please help
Jackson:
Quote from: roku3 on June 27, 2016, 09:26:25 am
Note: I said SOMETIMES, i.e. it was fine last night that I could receive incoming calls, and then just now the incoming calls goes directly to VM, which I didn't activate. out-going calls, however, has no problems.
=================================================
device: obi100
canada freephoneline
router tplink ac3200, obi100 hard wired to router, sip alg was disabled in router.
Firmware Version: 1.3.0.2815
2ay, it went to directly to VM again. it's like on and off randomly while during the whole period I didn't do anything to it.
Well you may as well update your your FW to the latest. You are a few updates behind. Can't hurt.
https://www.obitalk.com/forum/index.php?topic=11252.msg73904#msg73901
Follow SteveInWA's procedure.
roku3:
Quote from: drgeoff on June 27, 2016, 03:00:34 pm
Not sure why you say "no solution". The retry period is not the problem. Try increasing the RegistrationPeriod.
because the last post of my above link, someone tried following all the suggestions and still ended up in the same situation like i'm in now. sometimes works, sometimes goes to vm, that was back in 2013. my registrationperiod is 3600, that's the value in the setup guide. what other value should I try?
roku3:
Quote from: Jackson on June 27, 2016, 03:18:59 pm
Quote from: roku3 on June 27, 2016, 09:26:25 am
Note: I said SOMETIMES, i.e. it was fine last night that I could receive incoming calls, and then just now the incoming calls goes directly to VM, which I didn't activate. out-going calls, however, has no problems.
=================================================
device: obi100
canada freephoneline
router tplink ac3200, obi100 hard wired to router, sip alg was disabled in router.
Firmware Version: 1.3.0.2815
2ay, it went to directly to VM again. it's like on and off randomly while during the whole period I didn't do anything to it.
Well you may as well update your your FW to the latest. You are a few updates behind. Can't hurt.
https://www.obitalk.com/forum/index.php?topic=11252.msg73904#msg73901
Follow SteveInWA's procedure.
thank you. updated. before I updated, tried 3 times, twice worked. after updated and just tried, worked. will keep testing in next few days, will report back. hope this will resolve the issue.
Navigation
[0] Message Index
[*] Previous page