PBX setup with Obi202 moving from expired Obiplus subscription
ppppplus:
I found the issue!
It was here:
ITSP Profile D/SIP/ProxyServerPort should have been 5063, but was set to 5064, left over from one of my many configuration trials!
Again, thank you so much Dr Geoff and azrobert!!!!
Now I'll try to add that second ip phone. Baby steps.
ppppplus:
Quote from: azrobert on July 03, 2016, 08:43:51 pm
You can route inbound calls up to 4 devices including the phone port. You can do more with a hack. You would need to increase the MaxSessions parm. I'll explain after you get outbound to work.
I was actually finding that adding another ip phone isn't as apparently an extension of what was needed to setup the first ip phone and I was wondering if you happen to have some time on hand, if I could enlist your assistance for nudging me in the right direction.
Cheers!
azrobert:
To register a 2nd phone you need to use the exact same credentials as the 1st including the username.
You have a misplaced parenthesis.
Voice Services>SP4 Service>X_inboundCallRoute:
{1001>(Msp1):SP1}
Route inbound calls by IP address and port number of the SPA504G.
Voice Services>SP1 Service>X_InboundCallRoute:
{ph1,SP4(1001@192.168.1.101:5060),sp4(1001@192.168.1.102:5060)}
You said:
"3) enable "register" on the SPA504G itself"
Does that mean to can make calls without registering the SPA504G?
If you can, setup the 2nd SPA504G without registration and a username=1002
Then:
Voice Services>SP4 Service>X_inboundCallRoute:
{1001|1002>(Msp1):SP1}
Voice Services>SP1 Service>X_InboundCallRoute:
{ph1,SP4(1001@192.168.1.101:5060),sp4(1002@192.168.1.102:5060)}
___________________________________________
Check the status of SP4 to verify the IP address and port number of the SPA504G.
Status -> System Status
Only the last device registered will be displayed.
___________________________________________
Each inbound or outbound call uses 1 session on the OBi202 trunk.
When you get and inbound call and route it to SP4, it will use one session on SP1 and 2 on SP4 (1 for each extension).
This also applies to outbound calls.
Anyway, you need to allow for the max number of simultaneous active calls on each trunk.
If you exceed the maxsesions the call will fail.
You can just set max sessions to a large number like 5 or 6.
Voice Services>SP1 Service>MaxSessions: 5
Voice Services>SP4 Service>MaxSessions: 5
ppppplus:
fantastic! again, I thank you so much for the detailed information as I got ip phone 2 up and running. The last thing that I was wondering about was if the configuration can be tweaked such that the two ip phones can have intercom capabilities and/or call transfer capabilities.
Cheers!
Navigation
[0] Message Index
[*] Previous page