Dialing ***1 to gain access to Obi Web page

(1/1)

Bluesters:
I have an Obitalk 100, I am currently connected.
I am trying to find the webpage of my Obi by dialing ***1 but once I do that my obi goes from green to blinking red and disconnects, I also get a message on the phone stating there is an error. I then have to unplug the power cord from the obi and replug in to get connected again
It was always 192.168.1.8, but now it states no page found

SteveInWA:
Gee, that's odd.  Does the OBi currently work?  Can you access it via the OBiTALK dashboard?

Without more information, it's hard to say whether it has a hardware failure (failing power supply or failing OBi) or just needs a factory reset.

Bluesters:
Yes, it is working
I was able to find my OBI webpage through my router, which is now different than before, weird.

Everything is working fine, I'm just puzzled though because I read in the instructions to dial *** then 1 , the attendant instead of telling me my webpage address says "No service configured error, please log into obitalk.com and configure your device.
I log into obitalk.com and like I said I am connected so I assume I am configured correctly.

HHinFlorida:
Try a different physical phone. Maybe the DTMF frequencies are out of spec..

Navigation

[0] Message Index