OBI100 wont stop flashing red/green
Bluesters:
I have tried every troubleshooting step and my device will not stop flashing red/green
I downloaded the latest firmware 2886 with no luck.
I also looked up my ip address in my router and it does ping.
My address is 192.168.3, yet when I put that in my browser, the web portal does not open, it just brings me to a page that says the following:
Select file to update firmware Choose File Press Update to Start Process Update
WARNING
Please DO NOT disconnect the power from the device during the update process!
The process will take approximately 30 seconds to complete.
I also tried the following:
Alternating Red/Green A unit with red/green alternate flashing means that there was a power loss in the midst of a firmware update of the OBi. It is possible to recover the OBi. Try power cycling the OBi, first. If the light is still alternating, you will need to reinstall your firmware.
Click here for further recovery instructions
Please help, thanks in advance
Bluesters:
I also tried a factory reset but the OBI will not reset after inserting pin in back of unit
Taoman:
Quote from: Bluesters on August 20, 2016, 11:40:08 am
I also tried a factory reset but the OBI will not reset after inserting pin in back of unit
And you are following these instructions to the letter?
Quote
Reset the OBi Device Using the Physical Pin (Button)
1. With a paper clip (or similar) depress the reset pin located at the bottom of the OBi.
2. While keeping the reset pin depressed, plug-in the power cord.
First, the Power LED will turn red, then become sold green.
Keep depressing the reset pin while this is occurring.
3. After 10 seconds, the Power LED will start to flash green (slowly).
You may now release the reset pin.
4. Within 5 seconds, the Power LED will start to flash green rapidly for about 3 seconds.
5. Next the Power LED will change to red briefly indicating the OBi is now rebooting.
drgeoff:
Quote from: Bluesters on August 20, 2016, 11:34:19 am
My address is 192.168.3, yet when I put that in my browser, the web portal does not open, it just brings me to a page that says the following:
Select file to update firmware Choose File Press Update to Start Process Update
WARNING
Please DO NOT disconnect the power from the device during the update process!
The process will take approximately 30 seconds to complete.
Does that process go to completion without error?
Bluesters:
The answer to both questions above is yes.
Followed the reset instructions to the letter
and yes, the page that shows only the firmware update page allows me to update the OBI, it does update but then just goes back to flashing red/green
Navigation
[0] Message Index
[#] Next page