registration to sigpgate failed
gworona:
I installed xlite (on a computer that is not on my home network where obi is) and using the same sip-id and sip-pw was able to register and receive a call from my cell phone to xlite. Eventhough SP1 is successfully using google chat could the problem still be my router? I had problems in the beginning setting up the obi with google until obi support had me put a switch (I used another router) between the obi and the router. That fixed it. If you think the router could be the problem, I can go somewhere else with the obi to use another kind of router.
Should I try that? Or is that a waste of time and I should try something else?
Thanks for your advise.
QBZappy:
gworona,
Hi,
1) Did you try connecting directly to the DSL modem?
2) If you are up to it I noticed that your router is supported by DDWRT or Tomato firmware. You might consider flashing the router. Mind you this is not for the faint of heart.
http://vidmar.net/weblog/archive/2007/08/23/tomato-firmware-for-linksys-wrt54gglgs.aspx
gworona:
FIXED!!!
It wasn't my router firewall as disabling it didn't change anything.
Just to be sure I installed xlite on a computer behind the router and xlite registered and received a call.
Once I configured sipgate from SP2 to SP1 (as someone suggested or did in another post), it worked. That's kind of disappointing but you can't argue with success.
RonR:
Sipgate works fine on SP2. I just configured SP2 with my Sipgate account and had no problem registering, making outgoing calls, or receving incoming calls.
Navigation
[0] Message Index
[*] Previous page