"To place a call press 2, or to change your settings press 4"

<< < (2/2)

SteveInWA:
It should work by default, using automatic DTMF method selection, but you can try forcing DTMF (Touch Tone) to use the "Inband" method, as drgeoff posted above.

On the OBiTALK web portal, click your device, then get into expert configuration mode, and go to Service Providers-->ITSP Profile A General (or B, C, or D, depending on which SP you are using with Google Voice) and change DTMFMethod to InBand.  You need to un-check BOTH boxes to the right of the setting to change it from the default.  Click the Submit button to apply the setting change.

JamesJay:
Well honestly I have no clue exactly what you guys are talking about :-[.... but I found the problem.



'Primary Line for Outgoing Calls' was not checked, I checked off "phone 1" and that fixed it. I guess the last time I set up GV I missed that.   Thanks guys! :)

JamesJay:
Quote from: SteveInWA on September 22, 2016, 01:36:39 pm

It should work by default, using automatic DTMF method selection, but you can try forcing DTMF (Touch Tone) to use the "Inband" method, as drgeoff posted above.

On the OBiTALK web portal, click your device, then get into expert configuration mode, and go to Service Providers-->ITSP Profile A General (or B, C, or D, depending on which SP you are using with Google Voice) and change DTMFMethod to InBand.  You need to un-check BOTH boxes to the right of the setting to change it from the default.  Click the Submit button to apply the setting change.


Hey thanks again for helping me out with my problems Steve! ....Even though my problem is fixed I figured id better have a look at what you are talking about for future reference. I got into expert config. mode but I am uncertain what to do after I get to the expert config. mode.vv

the button vv

expert configuration mode vv

SteveInWA:
Click "Enter OBi Expert" and continue to the instructions I posted.

Navigation

[0] Message Index

[*] Previous page