Email alert when server not registered

(1/2) > >>

gabwey:
Good evening,

I have an OBI100 with a netgear 7000 router.  When there is a power failure, my FreePhoneLine server fail to reconnect.  I have to manually reboot the OBI100 and everything works fine afterwards.  The annoying thing is that I need to "miss" a call and receive a answering machine message to know that the device is not working.

Is there a way to get and email alerting me when the FreePhoneline Server is not registered?

Thank you.

drgeoff:
There is no way to make an unaided OBi do that.

Two possible ways using a computer would be:

1.  A program which logs in to the OBi's GUI and periodically does a capture of the html of the System Status page and parses it, examines the relevant section and when appropriate fires off an email.

2.  Similar to the above but using the OBi's ability to send logging messages to a Syslog server.

azrobert:
I suggest checking the firmware on both the OBi100 and your router. Upgrade if you're not at the current level.

If that doesn't work and you don't have the technical skills to do what drgeoff suggests then just place the OBi100 where you can see the LEDs. If FPL is not registered the phone LED will be off. This assumes FPL is your primary line.

OBi100/110 Build 2886:
http://fw.obihai.com/OBi110-1-3-0-2886.fw

Netgear R7000:
http://downloadcenter.netgear.com/en/product/R7000#searchResults

gabwey:
Thank you for your kind help!

The problem happens when the router reboots.  Google Voice (SP1) connects fine, but FreePhoneLine status is always:
Register Failed: No Response From Server (server=192.168.2.1:0; retry in 5s)e only

The only I have found to fix the problem is to manually reboot my OBI100 after the router reboot is completed.

Do you have an idea how I could fix the problem and have the OBI100 reconnect normally after the router reboot?

thanks

SteveInWA:
The OBi should (after some time) automatically register with the SIP server again.  Freephoneline has some unusual settings, compared to most service providers.

I suggest that you read and follow the linked guide and reconfigure your OBi.  Note that the guide was written for the OBI 100, but the settings are the same regardless of which OBi you use.

http://forum.fongo.com/viewtopic.php?f=15&t=16090

Navigation

[0] Message Index

[#] Next page