My OBi200 suddenly stopped working

(1/3) > >>

ashmah24:
I recently moved to a different place when I connected my OBi200 I was able to receive and accept calls for couple of days. After a week or so I started hearing a bad tone while dialing a number and the call never goes through (both receive and accept). So logged in to my profile an removed my device and now trying to add the device again but add device prompt never comes up with the configuration page.

I tried most of the troubleshooting methods in the support center like reset of device but same problem.

Can some help me resolve his problem.

Note: I am configuring my Google number.

drgeoff:
Dial **9 222 222 222.  Do you reach the Obihai echo test?

ashmah24:
No any number dialed will give me blink tone as if the call didn't go through.

ashmah24:
So did reset the OBi200 device again and logged into obitalk clicked on "Add device" and followed the instruction of dialing **5 {4 digit} number and heard a voice on my phone saying
"No service configured error please logging in to the obitalk and configure your device." As I am already logged in I see no effect on the setup screen! Then the setup timeout and give me instruction to do echo test. So when I go to dial that number I hear a continuous blink tone as if the call is not going through

drgeoff:
What message do you hear when you dial ***1 ?

What is the status of the OBi200's Power LED?

Navigation

[0] Message Index

[#] Next page