Obi 110 still half duplex

(1/2) > >>

SimonB:
Hi,

My Obi110 network port is stuck in 100 half duplex. I used the code
*** 0 27 1 1 1 hangup to set too 100mbps but this is still half duplex. Is there a code for full duplex or is this not possible?

See here: https://www.obitalk.com/forum/index.php?topic=3788.0

Thanks

Simon

drgeoff:
Are you really dialling that?

You need to dial the ***0 and listen to the prompts which tell you what to do and when to follow each entry with the # key.

SimonB:
Hi,

No I'm not dialing that literally. I followed the instructions in the linked thread. Sorry I wasn't being very clear.

The code 27 appears to set the network speed but not the duplex. My router has issues with half duplex and it causes dropouts and affects my work VPN.

Is there a code for full duplex?

Thanks

Simon

drgeoff:
According to the official page http://www.obihai.com/support/troubleshooting/sg/drop that code is for full duplex.

How do you know that your Obi110 is still in half duplex mode?

SimonB:
Hi,

When I plugged it into my router and raised a support call they told me that the MAC of the obi was 1/2 duplex. I've also moved it to a Asus RT-AC56U running Merlin firmware and the status page tells me the MAC is still 1/2 duplex.

I'm wondering if the length of ethernet between switch and obi is a factor (approx 20m) or somehow the wiring is badly done. However I'm not going to be able to move it easily as it's near the phone base station.

It's not a big deal since SIP over UTP can handle it quality wise and moving it off the router lets the asus deal with any dropped frames. I just like to have things all squared away. If only I could get SIP over SSL working properly (it's a old cert thing or SSLv2 AFAIK)...

Simon

Navigation

[0] Message Index

[#] Next page