Obitalk Provisioning Issue

(1/3) > >>

earthtoobi:
i Made changes to SP1 service in obiexpert and i could see the changes go to my device. Now, when i change my settings back  in obiexpert, the changes are not flowing down to the device correctly.(the device rebooted after the obiexpert changes).
these changes were related to callforwardonnoanswerenable related settings.
refer the screenshot attached

bitstopjoe:
 Make sure you are disabling Auto Provisioning otherwise none of your settings will take..
 Unless, of course, I am misunderstanding what you are asking. Knowing me that is entirely possibe :)



Joe Sica

RonR:
Auto Provisioning must be enabled to configure the OBi through the OBiTALK Web Portal.  If Auto Provisioning is disabled, changes made at the OBiTALK Web Portal will not affect the OBi.

Auto Provisioning must be disabled to configure the OBi locally.    If Auto Provisioning is enabled, changes made locally will be overwritten by the OBiTALK Web Portal.

earthtoobi:
auto-provisioning is enabled always.
to get around the issue, i set the obi device values to default and forced a reboot(with provisioning On).it synced up fine.
while there is workaround, was wondering if the auto-provisioning was airtight

OBiSupport:
Just re-state here, if you need to make any configuration changes through OBiTalk (OBiExpert surely included),  you need to turn on auto provisioning.

Earthtoobi, we are not clear about your problem described here, could you send a email to us at support@obihai.com, along with your 9-digit OBi number. Once you have auto provisioning turned on and uncheck OBiTalk Setting box on the right column, you should be able to freely configure your device. No workaround is necessary.

Navigation

[0] Message Index

[#] Next page