Non-US Dial plan.

(1/3) > >>

atikansari:
I setup my device as fallows
SP1 = Action VoIP
SP2 = Google Voice
Default Line = PSTN
Panasonic Phone Connected to Phone Port

and my Phone Port DigitMap as follows:
(xxxxxxxS2|0[1-9]xxxxxxx|<**1>00xx.|xx.|<**2>001xx.)

Now I can call my 7/9 Digits though PSTN Landline, International Calls though SP1 and US calls Though SP2 but I can’t make calls using **1/**2 method. Any Idea?

RonR:
You took out all the logic for:

1. Single-stage dialing to other OBi's
2. Speed Dials
3. Access to the Auto Attendant
4. Access to the Configuration Menu
5. Direct access to the LINE Port
6. Access via **1/**2/**8/**9
7. Access via the PrimaryLine
8. 911 support

In most cases, it's best to leave the PHONE Port DigitMap and PHONE Port OutboundCallRoute totally unchanged and set at Default.  DigitMap changes are usually best made at the respective trunk's DigitMap (ITSPx/LINE Port/OBiTALK).

If you state your objectives, I'll try to help you with an example configuration.

atikansari:
My Objective is very simple. when i want to dial local numbers i don't want dial **1/2/8 before the numbers. i want to dial the numbers only. for example. if i dial the 7/9 local numbers it should go trough PSTN. 00(International) will go though SP1 and 001(US) number with SP2.

Thanks.

RonR:
Physical Interfaces -> PHONE Port -> DigitMap : (Default checked)

Physical Interfaces -> PHONE Port -> OutboundCallRoute : (Default checked)

Physical Interfaces -> PHONE Port -> PrimaryLine : (Default checked)


Physical Interfaces -> LINE Port -> DigitMap : (xxxxxxx|0[1-9]xxxxxxx|<**1>00xx.|<**2>001xx.)


Service Providers -> ITSP Profile A -> General -> DigitMap : (00xx.|(Mipd)|[^*]@@.'@'@@.)


Service Providers -> ITSP Profile B -> General -> DigitMap : (001xx.|(Mipd)|[^*]@@.'@'@@.)

atikansari:
Thanks RonR for your help. But still i can't dial using SP2 by dialing **2009140xxxxx format. getting busy tone when i try to call.
because may be explicitly define that only 001 number should go though SP2 and 00 numbers should go through SP1.

Navigation

[0] Message Index

[#] Next page