SOLVED OBI200 and Cisco SPA303
azrobert:
Check if the IP phone is registering to OBi200's SP4.
In OBi Expert go to Status -> System Status
If the phone is registered, SP4 Status will show the phone's IP address and port.
If the phone isn't registering, it must be able to call without registration.
Voice Services -> SP4 Service -> X_Proxy: Unchecked
Voice Services -> SP1 Service -> X_InboundCallRoute:
ph,sp4(OBi200@xx.xx.xx.xx:port)
xx.xx.xx.xx:port is the IP address and port of the phone.
Turn registration off on the phone.
This is an OBi200 bug that prevents some devices from registering. I don't know if this bug has been fixed, so this might be another problem.
MGS19:
Thanks azrobert! I double checked these settings and changed what wasn't correct. Still the same issue. I've attached a document with some screenshots of my current configuration. Any help with figuring this out is greatly appreciated. Thanks
azrobert:
Voice Services -> SP1 Service -> X_InboundCallRoute:
ph,sp4(OBi200@xx.xx.xx.xx:port)
port is the Cisco phone's Listening Port, not Proxy Port. This usually defaults to 5060, but I know nothing about Cisco phones.
For a test try this:
Voice Services -> SP4 Service -> X_InboundCallRoute: ph
Make a call from the Cisco phone. If the phone attached to the OBi200 doesn't ring then the call isn't getting to the OBi200 and I would suspect a configuration problem on the Cisco phone.
MGS19:
Ok I changed the port to the default as you pointed out. I also tried the test. The Cisco phone did not rig the analog phone attached to the OBi200. So your thinking it's something with the Cisco phone setup. Thanks at least I have a place to start looking.
MGS19:
Also on the OBi200 the System Status for SP4 says "Registration Not Required" and that's it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page