Obi202 Setup GV and Local Line

<< < (2/2)

drgeoff:
I think you are saying that your VoIP "line" appeared on a socket into which a phone would usually be plugged, but in your case that socket was connected to the LINE socket of your OBi110.

If that is correct then I already addressed that in my first reply. Although you do not have a POTS line, your VoIP service appears on an interface which emulates (ie has the same electrical characteristics) as a POTS line.  And you cannot plug that into an OBi202. It won't work and may damage the OBi202.

You either need to get an OBiLINE and plug it into the USB socket on the 202 or use the 110 either by itself or in conjunction with the 202.

Why do you want to use a 202 instead of the 110?

azrobert:
You can route calls from the OBi202 over the OBiTalk network to the OBi110 and then out the Line port. Make the following configuration changes with OBi Expert:

OBi202:

Physical Interfaces -> Phone1 and 2 Port
PrimaryLine: OBiTalk Service

Add the following to the beginning of the OutboundCallRoute:
{(1xxxxxxxxxx):sp1},{(<200123456*>xx.|222222222):pp},

Replace 200123456 with the OBi number of the OBi110

Voice Services -> OBiTalk Service
DigitMap: (xx.S3)

InboundCallRoute: ph,ph2

OBi110:

Voice Services -> OBiTalk Service -> InboundCallRoute:
{510123456>(xx.):li}

Physical Interfaces -> Line Port -> InboundCallroute:
ph,pp(510123456)

Replace 510123456 with the OBi number of the OBi202

Navigation

[0] Message Index

[*] Previous page