adding 3rd GV# to OBI200

<< < (2/2)

SteveInWA:
What I am trying to tell you is that each and every SP that you want to configure with Google Voice must be configured on the OBiTALK web portal.  Forget about the local webserver config page; it cannot be used at all to configure Google Voice, and there is no good reason to use it.

SteveInWA:
And, I am telling you to reset and start over, because there are certain conditions under which the two configurations (local vs. OBiTALK) can get out of sync, and refuse to get back in sync, no matter what you do.  It is faster to just start over.  It takes less than five minutes per SP to set up.

bill-cary:
thanks Steve
I like my definition better. It is simple and clear and it works.

the FIRST time you add an SP to an OBI you must configure it on OBITALK then set the OBI to auto provision for OBITALK. Reboot the OBI and it will authenticate. After that you can change the config on the OBI and disable auto provisioning if wanted.

I did not reset the OBI - what a waste of time that would be. I would have to reconfigure all previous SPs just to add one by your plan. That equates to the pat answer - reinstall Windows. Not my favorite thing to do.

SteveInWA:
You MUST use the OBiTALK web portal EVERY TIME you want to configure a Service Provider slot with Google Voice. 

If you won't do that, then you are on your own.

Navigation

[0] Message Index

[*] Previous page