SOS obi110 not dialing out - all of a sudden

(1/2) > >>

RobertThompson:
Hello:

All of a sudden my obi110/anveo system stopped working. I get a dial tone. I can call the echo test.

I cannot reach any dialed number. After dialing I get empty air. The obi says that it is registered. anveo says that it is registered.

This happened over night. It worked fine yesterday. No changes were made to the system.

Any help would be greatly appreciated.

Rob.

Taoman:
What does the Call History on your OBi device show for those calls?

I had a somewhat similar issue happen to me yesterday on my OBi110. Even though my VoIP.ms trunk was registered I couldn't receive any inbound calls. Outbound calls worked fine. I checked the CDR on the VoIP.ms portal and I could see the incoming calls were hitting VoIP.ms as expected. I then used a softphone and registered to the same account. Incoming calls worked fine so I knew the problem was with my OBi device. I futzed around for about half an hour trying to figure out the problem but I had made no changes and could see no issue.

So I blew away my VoIP.ms configuration on the OBi and remade it. That got things working again and it's been fine since. You might try registering to Anveo with a softphone if that's an option for you and see if things work or not. At some point you have to measure your time spent troubleshooting against simply deleting and remaking your Anveo trunk configuration.

RobertThompson:
Thanks Toaman. :)

I did what you suggested but to no avail.

Cannot call in or out on Anveo.

Setup voip.ms on SP2 and can call in and out with no problem.

Any further suggestions, anyone?

Thanks,

Rob.

Taoman:
Quote from: RobertThompson on May 15, 2017, 02:42:28 pm


I did what you suggested but to no avail.



Really? Then what did you see in the OBi call history after attempting an outbound call?

Which softphone did you use to test your Anveo account? Were you able to register to Anveo?

Can you see the incoming calls under Calls Received in the Anveo web portal?

RobertThompson:
Hi Toaman:

I don't see "Obi Call History" under Expert Configuration...

I see nothing under "Call Status".
I see nothing under "SP1 & SP2 Call Stats"

I see no outgoing call in Anveo CDR

If I call in, the phone does not ring but I do see the call in the Anveo CDR.

Rob.

Navigation

[0] Message Index

[#] Next page