Flashing Red/Green after power outage. HELP!!!
davepatel:
hello all,
i have a flashing red/green after power outage. follwed instructions to install firmware manually. did this 3 times. after each time...device goes back to flashing red/green. please help. thanks.
SteveInWA:
Try this:
Unplug all three cables from the OBi (phone, Ethernet and power).Turn the OBi over and locate the reset switch, which is recessed under a hole, surrounded by a raised bump.Using a straightened-out paper clip, gently depress the switch until you feel a click, and keep it depressed. It's easier to do this by placing the OBi upside-down on a table, holding the box down with the heel of your hand, and the paperclip with your fingers, and then plugging in the power cord with the other hand.While continuing to hold down the switch, plug in only the power cord. Keep holding the switch and wait 10 seconds.Release the switch, and wait for the OBi to reboot.
Is it still blinking red/green? If so, it was fried by the power outage. Time to buy a new one.
davepatel:
followed it...within 10 secs of pin pressing...it goes back to red/green flashing....so there is no other way at this point to fix this device? OBI200
SteveInWA:
It's hammer time.
drgeoff:
If you have another 12 volt wall-wart with a plug that fits the OBi and centre positive, give it a try. You have nothing to lose.
Navigation
[0] Message Index
[#] Next page