Obi1032 Call Forwarding Unconditional

(1/1)

N7AS:
I never use Call Forwarding but have to use it now. I set it up on my Obi1032 and it works except for one important thing. No audio either way. Was there a firmware update that broke this function?

drgeoff:
During a forwarded call, have a look at the 1032's 'Status, Call Status' page on the local web interface or the portal expert mode.  Any clues there such as no packets in one of the legs, no codec in common etc?

N7AS:
Quote from: drgeoff on May 24, 2017, 11:58:33 pm

During a forwarded call, have a look at the 1032's 'Status, Call Status' page on the local web interface or the portal expert mode.  Any clues there such as no packets in one of the legs, no codec in common etc?


I just looked at my Call Status. Codec: tx=G711U rx=G711U (bridged) on both Terminal 1 and 2. So those should be ok.

As far as RTP Packets:
RTP Packetization: tx=0; rx=0 (bridged)
RTP Packet Count: tx=0; rx=0
RTP Byte Count:    tx=0; rx=0
On both Terminal 1 and 2

Navigation

[0] Message Index