September 30, 2020, 03:30:50 pm *
Welcome, Guest. Please login or register.
   Forum Home   Search Login Register OBiTALK  
Pages: [1]
Author Topic: Home Office Setup (dedicated line to office only, shared home/911 service)  (Read 1244 times)
Posts: 1

« on: July 10, 2017, 08:59:27 pm »

I am a newbie and would like help with the following that I suspect uses master/slave setup across my two Obi200s.

I have 2 Obi200's in my home (same address) to support a private line into my home office.  The primary Obi200-Home is handling the phone service for the home (SP1) and is using Anveo on SP2 for E911 services.

The second Obi200 is in my home office, where I am setup for a separate voip phone service that only works in my office (so that I can make business calls un-interrupted), currently using SP1.  

I would like to extend the Obi200-office setup for two additional items.

1. I would like to also receive inbound calls from the Obi200-Home SP1 calls so that I can answer home calls when available.  While keeping my office business number as my primary outbound calling line.

2. I would like to make 911 outbound calls from my Obi200-Office through my Obi200-Home SP2 Anveo account (which is at the same street address) -- so that I don't need to pay for another Anveo 911 account at same address.

Would someone be so kind as to recommend the specific inbound/outbound dialing rules and fake provider setups between my two Obi200's to make this happen.  That would be a huge help.
« Last Edit: July 10, 2017, 09:02:07 pm by CraigSchafer » Logged
Hero Member & Beta Tester
Posts: 4030

« Reply #1 on: July 10, 2017, 09:53:16 pm »

You can use the OBiTalk network to route calls between the 2 OBi200s.
Use OBi Expert to make the following changes.

Home OBi200:

Voice Services -> SP1 Service -> X_InboundCallRoute: ph,pp(222222222)
This will route inbound calls to the office OBi200

Voice Services -> OBiTalk Service -> InboundCallRoute:
This will route 911 and 933 from the office OBi200 to SP2

Office OBi200:

Voice Services -> OBiTalk Service -> InboundCallRoute: ph

Physical Interfaces -> Phone1 Port -> DigitMap
Add |933 after 911 in the DigitMap

Physical Interfaces -> Phone1 Port ->
Add following to the beginning of the OutboundCallRoute:
This will route 911 and 933 to the home OBi200

Replace 111111111 with the OBi number of the home OBi200
Make sure you leave the *
Replace 222222222 with the OBi number of the office OBi200
Pages: [1]
Jump to:  

Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC