Can't configure providers after factory reset
Lewy1:
@QBZappy
After a factory reset it should be set to defaults and provisioning should be enabled. I did double check and it's set to "Periodically" as opposed to the dfault "System start". It's possible that it was changed after I restored from a backup.
@RonR
The backup worked, but I still have a problem if I want to change my provider, unless "I get my hands dirty" with expert mode. I would still like the option of en easy painless setup (which happens to be one of the Obi's selling points!)
Thanks guys for your advice.
QBZappy:
Lewy1,
Until you disable it, you will be getting OBi config from the OBi portal.
Lewy1:
That's what I thought, but i tried quite a few times after factory reset and had no success, as stated above. So I'm hoping someone can help me figure out why.
Thanks
RonR:
Quote from: Lewy1 on August 04, 2011, 02:25:04 pm
The backup worked, but I still have a problem if I want to change my provider, unless "I get my hands dirty" with expert mode.
Just for info...
OBi Expert Mode is simply an extenson of the 'simple' configuraion part of the OBiTALK Web Portal. If the
'simple' configuration part isn't working, Expert Mode isn't either.
Quote from: Lewy1 on August 04, 2011, 02:25:04 pm
I would still like the option of en easy painless setup (which happens to be one of the Obi's selling points!)
Like you're currently experiencing? :-\
Lewy1:
Expert mode is an extension of the web portal when configuring from the web portal, but when configuring on local network it works fine.
Navigation
[0] Message Index
[#] Next page
[*] Previous page