DigitMap rules in ITSP B not working in ITSP A
azrobert:
Is this for calls from the buzzer? How are you getting the call to your OBi? Does the call have a CallerID?
illicit:
I'll check sometime today but the buzzer makes a local call to the Obi. And yes, I just need the forwarding for the buzzer calls.
azrobert:
Quote from: illicit on September 05, 2017, 11:24:37 am
I have a buzzer phone for the apartment and it rings a hard line that has no service, can I use the OBiLINE adapter to link it with the Obiai? I've read the website and I don't understand what FXO is but I presume my line is a PSTN or POTS?
I thought this meant you have a phone plugged into a wall jack and the buzzer rings that phone. You wanted to purchase an OBiLine adapter to connect your OBi2xx to the wall jack. Did you buy an OBiLine or an OBi212?
Line Port inbound route:
ph,sp1(phone#1,sp2(phone#2),sp2(phone#3)
or
The buzzer calls FPL or GV's inbound phone number.
SP1/2 inbound route:
{callerid:ph,sp1(phone#1,sp2(phone#2),sp2(phone#3)},.................
You need 3 open channels to initiate the calls. After the 1st destination answers the call, the other calls end so you only use 1 channel.
illicit:
The buzzer used to ring through the hard line but I changed the behavior with the management. It can dial out to any number. So I have it dial out to the Obi. Sorry I didn't update you guys regarding this. No need for an OBiLine.
I'll try the inbound route later today. It should work.
Navigation
[0] Message Index
[*] Previous page