Quote from: fmj77 on September 23, 2017, 08:22:19 PM
I have the Basic plan. I think the reason it's not working is because I used Vestalink easy config before. Not sure where to go from here.
I was wondering if you used that config file for Vestalink. Are you going to continue to use Vestalink? If not, I would do a factory reset on your OBi device and start from scratch. Even if you plan on continuing to use Vestalink I would take a screen shot of every config page for your Vestalink configuration. Then do a factory reset and manually configure Vestalink on SP2 using your screen shots as a guide. That is what I did when I had Vestalink and it worked fine.
Since you already configured Anveo with the Basic plan you'll need to "restore" that configuration. Assuming you configured Anveo on SP2 I would restore it to SP1 after the factory reset.
Note: After doing a factory reset you should still look thru the config pages on your OBi device and make sure everything is back to their default settings. If you see any red
! anywhere make sure you check the far right box and save your settings to bring it back to the default setting. That Vestalink config file changes a lot of settings. Make sure the ITSP Provisioning settings are all back to the default settings.