Condo Intercom to my cell phone?

<< < (2/2)

azrobert:
I never setup an intercom, so I don't have 1st hand knowledge on the procedure. I found the below link. Make sure you change the RingDelay to zero.

http://www.obitalk.com/forum/index.php?topic=10394.msg68560#msg68560

pingywon:
I dont know if the problem is with GV or what...


The intercom calls my cell...but my cell only rings once and it hangs up from the cell side....


From the intercom side... it keeps ringing.


So the intercom keeps ringing - it calls my cell. My cell rings once then hangs up. Then my cell rings again once and hangs ups - it just keep doing this.

I am sooo close....

anyone have any ideas?

pingywon:
pretty much went through all the GV settings, I dont think its  a GV problem at this point..based on process of elimination.

it is sooo close it has to be a simple something I am missing.

anyone?

drgeoff:
Log in locally to the OBi's onboard* web server GUI.  Click on Status and then on Call History.  You will see entries for both the incoming calls from the door pad and the outgoing calls to your cellphone.  They will show start and end times.  Which of incoming and outgoing show as one long call and which show as multiple short calls?

(* Call History cannot be seen via the OBiTALK portal.)

Kcontzen:
Just adding to this thread in case this information is helpful for anyone out there. I faced the same problem, the issue is the RingTimeout in the Physical Interfaces - Line settings. Try setting it to max, 1920ms. This is still not enough for my enterphone system, but at least it gave me 1.92 seconds to answer, which resulted in occasional success letting people in.

If the max isn't enough for you, get another ATA that permits a longer RingTimeout setting. SPA232d, Grandstream HT813 are examples.

Update: the SPA232d has more than one parameter named RingTimeout. The advertised one goes for as many seconds as you’d like. The “international settings” one that affects this issue has the same limits as the OBI110. Trying the audio codes mp 114, which seems to allow FXOBetweenRingTime of many seconds.

Navigation

[0] Message Index

[*] Previous page