December 13, 2017, 02:24:54 pm *
Welcome, Guest. Please login or register.
News:
 
   Forum Home   Search Login Register OBiTALK  
Pages: [1]
  Print  
Author Topic: OBI200 + Analog PABX  (Read 2250 times)
Clauber
Newbie
*
Posts: 9


« on: October 07, 2017, 06:20:00 am »

Hi Folks.

I need your help. I am trying to set my Obi200 with my current analog PABX Multitoc 308 and the issue I have is that every 2s it seems that Obi sends a signal that my PABX recognize as incoming call and then all my phones start ringing. I don't know how to do the settings to change this.

The setting I am trying to do is to connect the phone port from Obi200 to the Line (FXO) port in PABX. I did this with others ATAs on the same PABX and I never had this issue.

Right now, all setting value are as per the default setting in my Obi200.

Does anyone have any idea on how to fix this?

Regards,

Clauber.
Logged
drgeoff
Hero Member & Beta Tester
*****
Posts: 2713


« Reply #1 on: October 07, 2017, 07:29:39 am »

I cannot think of any settings on an OBi device that would cause this.

Have you performed the following obvious tests?

1. Plug an analogue phone into the OBi200.

2. Plug both an analogue phone and the PBX in parallel in to the OBi at the same time.
Logged
Clauber
Newbie
*
Posts: 9


« Reply #2 on: December 02, 2017, 09:05:59 am »

Yes. I did all that already and it always happen same thing.

I had before another VoIP ATA connected to the same PABX and this never happened, but with Obi200 I connect the phone port to the PABX and it starts to ring the PABX.

Regards,

Clauber.
Logged
SteveInWA
Hero Member & Beta Tester
*****
Posts: 3953



« Reply #3 on: December 02, 2017, 01:51:13 pm »

I wonder if the OBi is sending message waiting signals to its phone port, which are being mis-interpreted as ringing?  That would correspond to the two second cadence.

Plug in an analog telephone that has a call waiting lamp and see if it blinks.  Pick up the phone and listen for a stutter dial tone.
Logged

Pages: [1]
  Print  
 
Jump to:  

Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC