Install on a telephone switch - and thanks!

(1/2) > >>

alab310:
Obi200. I have had this device for awhile now and successfully configured gvoice and have a telephone number which is all good. I want to connect to a telephone switch box. I do not receive a dial tone after connecting. What do I need to do?

I tried searching the forum but did not find an answer. And thanks for any help!

drgeoff:
"telephone switch box" is not sufficiently informative. Can you provide a link to details of the specific item and explain what you are hoping to achieve.?

alab310:
I did some research and found this:

http://www.americantelebrokers.com/panasonic-vb42020-dbs616-ksu-refurbished.html

Link to the manual:

http://pdf.textfiles.com/manuals/TELECOM-F-R/Panasonic%20DBS%20308-616%20installation.pdf

I do see it it not voip capable as is. If I cannot use the Obihai, can you suggest a voip capable unit and still being able to use the phone I currently have installed?

And thanks!

drgeoff:
Quote from: alab310 on October 20, 2017, 09:28:23 am

I did some research and found this:

http://www.americantelebrokers.com/panasonic-vb42020-dbs616-ksu-refurbished.html

Link to the manual:

http://pdf.textfiles.com/manuals/TELECOM-F-R/Panasonic%20DBS%20308-616%20installation.pdf

I do see it it not voip capable as is. If I cannot use the Obihai, can you suggest a voip capable unit and still being able to use the phone I currently have installed?

And thanks!

That is a small PBX that goes between analogue phone lines and analogue or digital phones - not IP phones or ATAs.  You still have not explained what you want to do with it or what extra features/facilities you are seeking over and above those available from your existing OBi200 plus one phone.

The phone jack on your OBi200 emulates a phone line.  You can connect that directly to one of the 3 or 6 CO inputs on the Panasonic.  You can use an ordinary phone cord to connect to CO Line 1 or CO Line 4.  If you want to use any of the other CO Line inputs you will need a custom wired cable.  Use the centre two pins on the plug into the OBi and see Figure 8 on page 12 of the manual for the pins on CN1 or CN2 of the Panasonic.

alab310:
Thanks for the quick response!

What i want to do is just connect the Obihai unit to replace the basic service I receive from Frontier that I have now. I want to distribute the single line I have installed now for my residence. Later I'd like to upgrade the Obihai unit so that multiple lines can be accessed as I have a home/office. I have 150/150 fios so I believe bandwidth will not be a problem.

Navigation

[0] Message Index

[#] Next page