Distinctive ring by Service on OBi1022: X_DefaultRing setting wont work

(1/3) > >>

jamesatwork:
Greetings,

On OBi1022, I have been unable to set a distinctive ring by service (two GV services on SP1, SP2)

Expert Configuration -> Voice services -> X_DefaultRing wont impact the ringtone, even after changing the ringtone on the actual OBi1022 per page 59 of http://www.obihai.com/docs/OBi1000-IP-Phones-User-Guide.pdf?v=2

Thanks for any suggestions!

drgeoff:
Quote from: jamesatwork on November 06, 2017, 01:39:03 am

Greetings,

On OBi1022, I have been unable to set a distinctive ring by service (two GV services on SP1, SP2)

Expert Configuration -> Voice services -> X_DefaultRing wont impact the ringtone, even after changing the ringtone on the actual OBi1022 per page 59 of http://www.obihai.com/docs/OBi1000-IP-Phones-User-Guide.pdf?v=2

Thanks for any suggestions!

Your last post on this forum in another thread implies that you have chosen to configure your device using its local web interface and you have disabled Obitalk provisioning.  http://www.obitalk.com/forum/index.php?topic=13131.msg84273#msg84273

If so, why do you expect changing settings in Expert mode to have any effect?

jamesatwork:
Glad to see that someone has been tracking my posts :)

I have factory reset the OBi1022 (can confirm provisioning is now set back to Method: Periodically) and am programing it in Expert Mode

The particular OBi1022 will be installed remotely after completing setup and testing on my LAN of my three trusted units (other two will be an OBi202 and probably one OBi1062)

Thanks!

drgeoff:
X_DefaultRing selects 1 of 10 ring patterns (cadences) from the A or B collection.  Choice of A or B is made by X_RingProfile near the top of that list.  The 10 cadences in each of A or B are defined/editable in /RingSettings/RingProfile A or B.

The tone (music, jingle etc) itself is set in /Voice Services/SPx Service/X_RingToneFile.  There is no drop down select for that.  Type manually eg /data/ringtones/Office C.wav.  You have the inbuilt ones or you can load your own via USB stick.

jamesatwork:
Ring pattern (cadence) variation is what I am aiming for and though SP1 defaults to X_RingProfile A and SP2 to X_RingProfile B, I made sure the values of X_DefaultRing point to a different RingPattern cadence so that RingPattern 1 is 60;(.4+.2,.4+2) and RingPattern 2 is 60;(2+4)

Unfortunately, I still get the same ring no matter which service is called despite stickiness of changes on the obitalk portal

When selecting a non-default value for the ring pattern, which of Device Default | OBitalk RingPattern Settings should be checked, if any?

Thanks!

Navigation

[0] Message Index

[#] Next page