Ring one line at a time

<< < (2/3) > >>

GPz1100:
(#) is a place holder.. It's either ph1 or ph2.

In our config, sp1 rings phone line 1, sp2 rings phone line 2.  Neither rings the other - 1 line is for fax, other for another handset.

SP1


SP2

Morgen:
BigJim_McD,

what do you think if i have a 2 line phone plugged into ph1 and a separate phone to ph2 (so all in all i have 3 lines - 2 from ph1 and 1 from ph2)

is there any way i can make it ring only line one of ph1 first? and if busy line 2 of ph1 and if busy line 1 of ph2?

drgeoff:
Quote from: Morgen on November 16, 2017, 11:29:10 am

BigJim_McD,

what do you think if i have a 2 line phone plugged into ph1 and a separate phone to ph2 (so all in all i have 3 lines - 2 from ph1 and 1 from ph2)

is there any way i can make it ring only line one of ph1 first? and if busy line 2 of ph1 and if busy line 1 of ph2?

There are only two phone-set interface circuits inside the OBi202.  The PHONE1 jack is wired to both of them.  The PHONE2 jack is wired to one.  So one line of your 2-line phone and the only line on the other phone are commoned by physical wiring within the OBi202.  It is impossible to have the "3-stages" that you ask about.

Morgen:
Quote from: drgeoff on November 16, 2017, 11:59:44 am


There are only two phone-set interface circuits inside the OBi202.  The PHONE1 jack is wired to both of them.  The PHONE2 jack is wired to one.  So one line of your 2-line phone and the only line on the other phone are commoned by physical wiring within the OBi202.  It is impossible to have the "3-stages" that you ask about.

oh. my mistake. i got it.

Morgen:
Quote from: BigJim_McD on November 14, 2017, 01:53:55 pm

Morgen, 
We use an OBi202 with a two line portable phone for our Home phone service.

I configured the following OBi202 configuration settings using OBiTalk OBiExpert Mode.

Voice Services > SP1 Service > X_InboundCallRoute > {ph1}

Calling Features > CallForwardOnBusyEnable   [x} {Checked}
CallForwardOnBusyNumber    ph2(#)

Physical Interfaces > PHONE1 Port > PHONE Port > Calling Feature
CallWaitingEnable [ ]   {NOT Checked}



tried this but for some reason does not forward to second line.

do you have any idea why or how i can help this?

Navigation

[0] Message Index

[#] Next page

[*] Previous page