911 service output through Telco line, doesn't work. Obi 110 and 212

<< < (2/2)

azrobert:
BT (Bluetooth), PH2, SP3 and SP4 are not supported by the OBi110. You must have copied the digit map and outbound route from an OBi2xx and pasted them into your OBi110.

The following is the default digit map and outbound route from my OBi110 modified to add 611. 911 was already defined.

DigitMap:
([1-9]x?*(Mpli)|[1-9]S9|[1-9][0-9]S9|911|611|**0|***|#|**1(Msp1)|**2(Msp2)|**8(Mli)|**9(Mpp)|(Mpli))

Outbound Route:
{([1-9]x?*(Mpli)):pp},{(<#:>|911|611):li},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}

yehob150:
Thank you that worked!

I vaguely remember years ago I may have copied and pasted lines from these forums to enable that 911 line out but didn't realize that it was for 200 series only.

I also found how to shut off telco port incoming calls from ringing obi.

I guess I'll use your first set of lines for the 212 when that comes.
Thanks!

yehob150:
oh, on that note does the 212 ever go on sale?
I've only seen the 200 and 202 on sale (and 202 only in Canada!)

Navigation

[0] Message Index

[*] Previous page