Syntax for a Hotline in Outbound Calling Route

(1/2) > >>

TTCP:
Hi,

I want to create an outgoing hotline for my OBI200.

In the manual, it says:
    <:1234> – Matches an empty phone number and replaces with 1234. This is the syntax for a hotline to 1234
    <S0:1234> – Equivalent to the last example

But I found none of these two syntax works in my OBI200.

Can someone please help me here?

Do these hotline syntax require some special "DigitMap" field value in the "Physical Interfaces -> PHONE Port"?

My OBI200 firmware is 3.2.1 (Build: 5757EX)

drgeoff:
That <:number> construct goes into the PHONE port digit map as an addition. Insert

<:number>|

immediately after the opening ( . The number will then be subject to the routeing rules in the PHONE port OutboundCallRoute just as if you had manually dialled it.  (Use the actual number after the colon.)

Are you sure you want a hotline?  Using a "warmline" introduces a delay which lets you dial a different number or gives you a chance to put the phone back on-hook if accidentally knocked off.

<S5:number> will dial the number after 5 seconds if nothing is dialled.  Change the 5 to your liking.

munozj:
I'm sure this is something obvious but I can't seam to figure it out.. to make this work I'm assuming I need to replace the information in the Digit Map field of the Physical interface, Phone1 with <S0:5551212> for the device to automation dial 5551212 when the phone goes off-hook.  I've tried this but I only get dial tone when I pickup the phone.  I also tried <S1:5551212> and <S0:5551212>|

I'm assuming I'm just entering the wrong syntax in the wrong field but I'm not sure which field I should be using.

Using an Obi300

drgeoff:
Quote from: munozj on April 03, 2018, 08:46:59 am

I'm sure this is something obvious but I can't seam to figure it out.. to make this work I'm assuming I need to replace the information in the Digit Map field of the Physical interface, Phone1 with <S0:5551212> for the device to automation dial 5551212 when the phone goes off-hook.  I've tried this but I only get dial tone when I pickup the phone.  I also tried <S1:5551212> and <S0:5551212>|

I'm assuming I'm just entering the wrong syntax in the wrong field but I'm not sure which field I should be using.

Using an Obi300

Please do not ask the same question more than once.

SDToddl:
I too am having the same problem.  When you say this line is an addition,  do you put it inside
User Defined DigitMap1 under the ipd 
(xx.<*:@>xx?x?<*:.>xx?x?<*:.>xx?x?<*:.>xx?x?|xx.<*:@>xx?x?<*:.>xx?x?<*:.>xx?x?<*:.>xx?x?<*::>xx?x?x?x?)

or are you suppose to create a DigitMap2?

Just so I don’t have to add a followup question.  Where exactly do I put it if I want a hotline to dial 16193641234?

Ideally, I would like to have it if someone dials 18005551234 it sends the call to 16193641234.

Could you please tell me also how to do that so it will answer my question and the previous person’s question.

Thank you for your help

Navigation

[0] Message Index

[#] Next page