Use of more than 4 Voice Gateways in OBi110
N7AS:
I have 4 Voice Gateways setup like in this post: http://www.obitalk.com/forum/index.php?topic=526.0
I am using vg3, vg4, vg6 and vg7 with 4 whistlephone accounts using **3, **4, **6 and **7 + number. I uderstand **5 is used internally and can't be used to dial a number.
There are 8 Voice Gateways and would like to use some more in addition to the ones I am presently using. How would I do this? What would I have to enter before the phone number? What would I have to add to the DigitMaps?
My setup:
SP1 > Google Voice (Primary)
SP2 > Localphone
Line > PAP2T
RonR:
How 'bout going to a two-digit trunk specifier? Instead of (or in addition to) **7, for example, use **71, **72, **73. etc. That's where I put a couple of my seldom used providers.
Just have matching rules in the PHONE Port DigitMap and OutboundCallRoute.
N7AS:
RonR,
Thanks for the tip. I will have to try that.
Instead of using **xx as a trunk specifier, could I use something else such as a 2 or 3 digit number without the ** such as 00 or 123?. I may setup one VG for iNum. BTW, can you call an iNum for free from the US? Would the rules in the DigitMaps be the same, but subsitute the 2 or 3 digit number in place of **xx? Such as:
**2(Mvg2)| and {(<**2:>(Mvg2)):vg2}, ? Can I change them to something like:
123(Mvg2)| and {(<123:>(Mvg2)):vg2}, 0r 00(Mvg2)| and {(<00:>(Mvg2)):vg2},
RonR:
You can use most anything that doesn't get tangled up with an existing dialing sequence. For example, 123 is probably a bad choice because it would probably interfere with dialing numbers in area code 234 (12345551212).
The matching of PHONE Port DigitMap/OutboundCallRoute rules would take on the same form as the **3/**4/**6/**7 additions.
N7AS:
Ok, that makes sense.
How about calling iNum numbers? Would I get nicked $ if I call them?
Navigation
[0] Message Index
[#] Next page