SIP phones no longer connected after 3.2.1 (Build: 5794EX) Saturday 1/21/18

<< < (3/13) > >>

RFC3261:
Quote from: BlakeN on January 22, 2018, 04:23:18 pm

Trust me - I thought about saying I would be happy to pay them $10 to fix it.

There is the rub. Paying them $10 means they will answer the question, not that they will fix anything (everyone paying for service deserves an answer, sometimes the answer is no, and sometimes the answer is hell no).

[conjecture (zero value)]
I think some (including I) hope the answer will be another firmware update that restores the functionality they themselves documented, but times change, and perhaps that is no longer a supported configuration (in which case it would be nice if they said that, but they have no requirement to do so). That the blog entry was disappeared does raise an eyebrow, but given the complexity of the configuration (and I am guessing the support cost to help people work through it (that you and I and a few others managed it probably show the exception that proves the rule that it was not trivial)) that may have simply been a prudent business decision. Of course, OBiPLUS made it easy to configure one/two SIP phones. But they explicitly removed that too (at least for the "free" service).
[/conjecture]

TheLliez:
Since the update I get the following on my phone log:
Registration failed User: xxxx, Error Code:480 Temporarily not available

Is there a log on the obi202 side?

LarryDP:
Same issue with OBi 202 and 2 Polycom IP335 phones not registering. I made no change. Obi, what's the fix?

ProfTech:
What firmware was in your 202 before? I believe a couple of users reported they were able to (re) load 5757 to correct the issue. You may need to permanently remove the Obi from the portal to make the change "stick" though. If you remove it from the portal be sure and disaable all of the auto provisioning and disable obitalk.

Navigation

[0] Message Index

[#] Next page

[*] Previous page