SIP phones no longer connected after 3.2.1 (Build: 5794EX) Saturday 1/21/18
Taoman:
Quote from: BlakeN on May 10, 2018, 07:37:14 am
Anyone have the firmware 5757EX for Obi200? I have seem to lost it and the Obi site does not seem to be responding.
Just download it:
fw.obihai.com/OBi202-3-2-1-5757EX.fw
azrobert:
The fast busy indicates the call is getting to the OBi200, but is not getting routed to your provider.
The same routing should work whether the phone is registered or not.
Temporarily change the X_InboundCallRoute to: ph
This should cause the phone port to ring.
This test is to check if the call is getting to the OBi200.
Before making this change please post the X_InboundCallRoute of the dummy trunk.
You can't downgrade the firmware. You get a checksum error.
Taoman:
Quote from: azrobert on May 10, 2018, 08:04:48 am
You can't downgrade the firmware. You get a checksum error.
Thanks for confirming this, azrobert. I was afraid to even try as both of my OBi200s are working perfectly with 3.2.2 (Build: 5859EX).
azrobert:
Did you make any changes to block scanners, access list or block unregistered calls?
BlakeN:
Quote from: azrobert on May 10, 2018, 08:04:48 am
The fast busy indicates the call is getting to the OBi200, but is not getting routed to your provider.
The same routing should work whether the phone is registered or not.
Temporarily change the X_InboundCallRoute to: ph
This should cause the phone port to ring.
This test is to check if the call is getting to the OBi200.
Before making this change please post the X_InboundCallRoute of the dummy trunk.
You can't downgrade the firmware. You get a checksum error.
Turns out I have two problems. One of my GV numbers after the upgrade is not registering properly - comes up with connecting to an IP address. The other one after changes above received inbound calls (did not realize until my wife called) but fast busy on outbound. Will work to debug.
On other question - don't remember changing any of those - where are they buried in the config?.
I am getting invalid number on the Cisco phone along with fast busy when dialing. Are the dialing rules bypassed for some reason with the new settings? I tried 7,10 and 11 digit dialing and all gave same invalid number.
Thanks again for the help.
Navigation
[0] Message Index
[#] Next page
[*] Previous page