SIP phones no longer connected after 3.2.1 (Build: 5794EX) Saturday 1/21/18
Taoman:
Quote from: azrobert on May 10, 2018, 06:35:18 pm
I have the same GV account defined on an OBi200 as SIP and on an OBi110 as XMPP. Both are connected and working.
You're getting incoming GV calls on your OBi110? Since you can no longer forward to Google Chat how is that possible? I knew outgoing still worked.
azrobert:
Quote from: Taoman on May 10, 2018, 07:00:32 pm
Since you can no longer forward to Google Chat how is that possible? I knew outgoing still worked.
You are correct. Only outbound OBi110 works, not inbound. I'm routing inbound from my OBi200 to the OBi110. When OBi110 outbound stops working, I'll route outbound to the OBi200.
BlakeN:
Quote from: azrobert on May 10, 2018, 06:10:51 pm
Try this:
{>911|933:sp2},{>(Msp1):sp1},{ph}
Same outcome - fast busy / service unavailable (If I click back on X_EnforceRequestUserID error changes to Invalid number)
azrobert:
Try this:
SP4 X_InboundCallRoute: ph
When you make a call, does the OBi200 phone port ring?
If the phone doesn't ring, the call isn't getting to the OBi200 and I don't know why.
Do not do the following steps,
If the phone rings, do the following:
SP4 X_InboundCallRoute: sp4($1@192.168.1.99)
Dial a number on the IP phone, wait a few seconds and hang up.
You will not hear anything after dialing the number.
Now do this:
SP4 X_InboundCallRoute: sp4($2@192.168.1.99)
Make another call for a few seconds.
$1 contains the IP phone's userid and $2 the outbound number.
You should be able to see these in the OBi200 call history.
To access Call History:
Log directly into the OBi using the local interface.
Key the IP address of the OBi into a Web Browser and hit Enter
The UserID and default Password are both "admin".
Click Status on the left column then click Call History.
What does the call history show for those calls?
lottamoxie:
Obi 200 here. Was converted to new firmware several days ago.
My problem is this:
Inbound calls, my cordless phone rings once and then stops. The caller on their end is hearing a type of "number not in service" message.
I have no problem making outbound calls, I get a dialtone and everything works normally.
My GV status shows as connected on the Obitalk dashboard.
Any ideas?
Navigation
[0] Message Index
[#] Next page
[*] Previous page