FXS to FXO and FXO to FXS
Roddy:
Hello Azrobert,
Apologies for late response as I was sick like a dog with a terrible flu!
All of the above settings were precisely applied, and the SW is 1.3.0 (Build: 2886).
AA's Primary Line is set to PSTN.
However;
AUTO ATTENDANT isn't working on the PSTN LINE, hence if you dialed my landline you won't get
a prompt to dial through SP1 or SP2. It'll just ring!!
Roddy:
More screenshots...
drgeoff:
I cannot see why the AA is not getting the call. However I do see that you have not configured the LINE port to use correct or more optimum parameters for a UK line. See attached screenshot.
(Also suggest you redact the OBi number from your screenshot. Anyone with an OBi can call that - and, if you are using 1234 as the PIN, make calls on your accounts.)
azrobert:
I was able to reproduce your problem on my OBi110. The call just rings and doesn't get routed to the AA. I even tried routing the call to SP1 by using number sp1(1623594100) and it also failed, so the problem is with call forwarding and not the AA. My Call History showed the call routed to SP1, but ended after 2 seconds. The caller only heard ringing.
The only other way you can do this is to route calls to the AA by CallerID. If you do this, you won't need the PIN.
Physical Interfaces -> Line Port -> InboundCallRoute:
{0123456789:aa},{ph}
If you want to route more than 1 CallerID, separate them with a vertical bar:
{0123456789|0123456788:aa},{ph}
Roddy:
Dear azrobert,
Thanks for your response and simulating my issue.
Again, I tried call forwarding with no luck!
Have you tried it yourself?
On the other hand the fact that AA IS WORKING with SP1 & 2 BUT not PSTN is driving me crazy.
What was a breeze on SPA3102 is now an issue with OB110, though theoretically OB110 should be better!
Your input is more than appreciated,
Thank you,
Roddy
Navigation
[0] Message Index
[#] Next page
[*] Previous page