Can a pause be programmed into a Speed dial ?

<< < (2/2)

nlof:
Thanks Ron, I have the Obi100 so no joy :)

Stewart:
Quote from: nlof on February 02, 2012, 07:41:57 pm

Thanks Ron, I have the Obi100 so no joy :)

What is your specific application?  There may be a good solution.  Examples:

If you are calling a conferencing service, they may offer a direct SIP connection, where the conference ID is sent in the SIP URI.

If you are using a calling card for international calls, there is likely a VoIP provider with better quality and/or lower rates.

You may be able to use e.g. a free PBXes account to do the dialing.

nlof:
Thanks Stewart, your suggestions sound very interesting , I'll look into them (and especially the PBXes account) just so I know what Obi is capable of doing :)

In my particular case I was trying to use GV to speed dial a local access number for Sipbroker and after a pause (to allow it to pick up), dial a voip number.
As a workaround I used the additional outgoing gateway method (explained here http://www.obitalk.com/forum/index.php?topic=526.0 by RonR) to create a Sipbroker gateway in Obi and now I should be able to speed dial the Voip number directly...

Navigation

[0] Message Index

[*] Previous page