Submit = Reboot?
bsdaiwa:
When I use the OBi portal and make a change to my device then select Submit, does this cause the device to reboot?
If I don't make any changes but still select Submit on one of the setup pages does the device reboot?
I am trying to make sure I can reboot a device that is located in a remote unattended location.
drgeoff:
My test on a remote OBi100 indicates that a "Submit" even with no changes does cause a reboot.
I looked at the UpTime in System Status immediately before and immediately after such a "no change Submit". The UpTime was reset between the two observations.
GPz1100:
This is not the behavior of 200/202 models. A submit writes the changes, but one has to press the reboot button which actually reboots and makes those changes effective. There's a few areas where a reboot is not necessary. IIRC, edits to speed dial don't require a reboot. Might be some others.
drgeoff:
Quote from: GPz1100 on March 21, 2018, 09:58:58 am
This is not the behavior of 200/202 models. A submit writes the changes, but one has to press the reboot button which actually reboots and makes those changes effective. There's a few areas where a reboot is not necessary. IIRC, edits to speed dial don't require a reboot. Might be some others.
The OP and I are talking about "Submit" on the portal*, not the local web UI. There is no "Reboot" button on the portal.
* The clues are in the words of the OP, "When I use the OBi portal", and my "remote OBi100".
GPz1100:
Doh! Thanks...Overlooked that part, was thinking local management ui.
Navigation
[0] Message Index
[#] Next page