Incoming fax not working (Obi 200) because of "fax voltage tone"?
GPz1100:
Odd. We have a a Canon mf628cw connected to the obi202 here. Here's the settings I'm using for auto answer. It picks up after ~2 rings.
Also make sure the fax machine is indeed in auto mode (see pdf).
JTP-Admin:
The settings for fax are identical here.
Would you be so kind to see the ring voltage in expert Obi settings for 202 device? I wonder if it's higher there or if it's similar to Obi 200?
GPz1100:
From the status screen, while on hook and NOT ringing, tipringvoltage is 45V. When ringing ~ -43V to +62V as I refresh it.
Under physical interfaces it's all set to default as far as voltages and standards settings. RX/TX is modified for some reason (can't remember why I changed this), but no issues faxing at full speed.
drgeoff:
Quote from: JTP-Admin on April 16, 2018, 11:38:36 am
Tried setting it to 90
I don't know how the OBi interprets what you enter but I would not assume that entering a value above the stated range has the effect you seem to expect.
Not saying it will solve your problem, but if you don't try you won't know.
JTP-Admin:
If you could grab a screenshot of data right above port settings (ringer) - that's where the setting I was trying to change is located...
Navigation
[0] Message Index
[#] Next page
[*] Previous page