Google Voice1 from SP1 to Google Voice2 on SP2

(1/4) > >>

hruk79:
I am trying to do the sipmplest thing:
A call to GV1 set on the SP1 and want it to be forwarded to GV2, but it always fails.

There is now answer from Obi212 when calling to GV1 on the SP1, it is only about four tones and then sp1 google voice box.

There is now even ring on my GV2.

My changes is very small, both of GV1 GV2 is set up automaticaly.
SP1
X_InboundCallRoute {sp2}
AnonymousCallEnable checked

SP2 {ph}
AnonymousCallEnable checked

Both of GV works in stardard mode:
If I change SP1 X_InboundCallRoute {sp2} to {ph} it takes my ring to GV1 and forwards to ph, along with it take my call to GV2 on SP2 and sends it the phone. I can speak and hear too.

Help me, please. Alexey.

azrobert:
I don't understand what you're trying to do. When bridging a call like that you need to supply a phone number.
SP1 X_InboundCallRoute: sp2(18005551212)

If you want to get routed to GV#2 voice mail prompt, just use the GV#2 number.

hruk79:
I want any person(any number), who calls GV1 went through OBI212 to call to GV2.

azrobert:
Do you want any caller on SP1 to be able to make a new call using SP2? You can't just get a dial tone on SP2. You can route the call to the Auto Attendant. At the prompt enter 2 then the outbound number and a # after the 2nd prompt.

SP1 X_InboundCallRoute: aa

Voice Services -> Auto Attendant -> Primary Line: SP2 Service

hruk79:
Great. Thank you, I have done as you told and managed to call from my GV1 to aa and to hear the tone and to dial number on GV2. So there are another question

1) How to do call not through GV2, but call to GV2. For example, I call to GV1, and GV2 rings?

Thank you again.

Navigation

[0] Message Index

[#] Next page