Obi 100 - Line Select

(1/2) > >>

ArbitaryTwist:
I am trying to re-configure my OBI and i can't seem to get it to work.

I had previously set it up to use SP1 as the default line out and VG3 for Long distance. I had a Digit Map setup in ITSP Profile A for <**3>011xx. So any call to 011 was re-directed to VG3.

Since then i have changed my Default Line to PSTN. (Have a phone line connected to OBI110 & changed digit map to <**2>011xx. I have also disabled VG3. For some reason it still tries to call out VG3 and says service not configured. Am i missing something ? I also tried adding <**2>011xx. to digit map for Physical Interface >> Phone >> Digitmap but same outcome.

I would also like to add some numbers or area codes to make them call out via SP2. Not sure how to add these too.

azrobert:
Check to see if your changes are sticking. If you are using the local interface to configure the OBi110, OBiTalk will overlay your changes. You will need to disable OBiTalk Auto Provisioning on the OBi110 or use OBi Expert to make modifications.

ArbitaryTwist:
I have made the changes via ObiTalk.com and rebooted my OBI. Confirmed i can see the changes on the OBI Local Webpage.

drgeoff:
The digit map only affects what dialled numbers the OBi will accept. Routeing outgoing calls to a particular service provider is controlled by the OutboundCallRoute.

Use copy and paste to reply here with the Phone Port Digit Map and the Phone Port OutboundCallRoute.

ArbitaryTwist:
Phone Port Outbound Call Route >> {(Mvg3):vg3},{([1-9]x?*(Mpli)):pp},{(<#:>|911):li},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}

Phone Port Digit Map >> <**2>011xx.|((Mvg3)|[1-9]x?*(Mpli)|[1-9]S9|[1-9][0-9]S9|911|**0|***|#|**1(Msp1)|**2(Msp2)|**8(Mli)|**9(Mpp)|(Mpli))

Navigation

[0] Message Index

[#] Next page