OBi200 as a GV Gateway for an OBi100

<< < (2/3) > >>

zsak23:
I should be okay without registration then.

Thank you

azrobert:
If you want to configure this in steps:

Define GV#1 on SP2 then

Voice Services -> SP2 Service -> X_InboundCallRoute:
ph,sp4(0@yy.yy.yy.yy:5060)

Leave the OBi100 unchanged.

Outbound will go to GVGW
inbound will arrive at the OBi200 then routed to the OBi100.

This is what I did.

When this is working then complete the remainder of the config.

zsak23:
I've been watching the GVGW SIP testing 'cause doing nothing is the easiest path and disturbing the main household phone will disturb my luddite spouse (who has trouble using a cell phone).

Since you already have an OBi100 inbound routed to an OBi200, I'm interested in knowing the benefits of such a setup.  Obviously redundancy is one.

Thank you.

SkOrPn:
On my Obi110 I can make calls still, but I can't receive them (just tested as of today).

So my question is why would I need to keep the Obi110 if I get a Obi200 to replace it? Couldn't I just buy the Obi200 and set it up natively with GV and toss out the Obi110 (or sell it on ebay if it still has value)?

I am just confused why anyone would want to use the old Obi if they have a newer one?

zsak23:
I have both devices.  The Obi100 is connected to the phone lines in the house.  It would be easiest for me to link the 2 than to physically replace it with the OBi200.

Navigation

[0] Message Index

[#] Next page

[*] Previous page