How to setup local calls via line port (OBi110)

(1/4) > >>

kenth:
This must have been asked many times, but I can't find it.

I'd like my local calls to be via the line port on my OBi110. (It get's the right caller ID, among other things.) What is the best way to accomplish this?

Thanks. Kent

RonR:
If you'd like all calls to go out the LINE Port by default, set:

Physical Interfaces -> PHONE Port -> PrimaryLine : PSTN Line

Then to use another trunk:

**1 + number -> SP1 Service
**2 + number -> SP2 Service
**8 + number -> LINE Port
**9 + number -> OBiTALK Service

If you'd like something more automatic, like international calls to SP1 and all others to the LINE Port, give me the specifics and I'll try to help you with a dial plan that will accomplish it.

kenth:
Thanks for the help. Let me explain further.

What I was looking for is automatic selection of ports based on digit pattern. Basically, I want 7-digit calls thru the LINE port and 1+ and 011+ calls, etc, via google voice on SP1. Maybe I'll also put 611 to LINE & 411 to SP1, etc.

The actual problem is a bit more complicated since they're installing an overlay code here. But I used to program telephone switches for a living, so I think I can figure out the patterns if I can see how you route different patterns to different ports.

Thanks. Kent

kenth:
Great. So the trick is service providers.

Just to check, my ITSP-A is set to GoogleVoice. Should I leave this alone & setup ITSP-B for "local port" routing?

(If so, how do I get the ITSP-B page to be editable?)

Thanks.

Navigation

[0] Message Index

[#] Next page