News:

On Tuesday September 6th the forum will be down for maintenance from 9:30 PM to 11:59 PM PDT

Main Menu

OBi202 and 10/11-digit USA dialling

Started by jamieh, October 30, 2019, 01:20:19 PM

Previous topic - Next topic

jamieh

Hi all,

Apologies if this is an obvious one, but I'm using an OBi202 in the US and it currently requires the entire international number 001 etc. in order to dial US numbers (it's based on a NZ SIP service where 00 is the international exit code).

How can I configure my OBi202 to only require a 10 or 11 digit number - i.e. 1-xxx-xxx-xxxx or just xxx-xxx-xxxx? Whenever I dial these my service provider returns a 404 error.

Thanks!

Kasey00

#1
Quote from: jamieh on October 30, 2019, 01:20:19 PM
Hi all,

Apologies if this is an obvious one, but I'm using an OBi202 9apps in the US and it currently requires the entire international number 001 etc. in order to dial US numbers (it's based on a NZ SIP service where 00 is the international exit code).

How can I configure my OBi202 to only require a 10 or 11 digit number - i.e. 1-xxx-xxx-xxxx or just xxx-xxx-xxxx? Whenever I dial these my service provider returns a 404 error.

Thanks!

Ask this to your network operators . They knows exactly what works.

azrobert

jamieh,

Sorry for the delayed answer. I didn't see your post until now. Assuming your provider is defined on SP1 and SP1 is your Primary Line, use OBi Expert to make the following change:

Service Providers -> ITSP Profile A General

The default DigitMap is:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|011xx.|xx.|(Mipd)|[^*#]@@.)

Change it to:
(001xxxxxxxxxx|<00>1xxxxxxxxxx|<001>[2-9]xxxxxxxxx|xx.)