Connecting Panasonic IP phone KX-TGP600 with Obi202- in Proxy
lrosenman:
I used an ID I was given by Panasonic support a long time ago and keep in 1Password. Access to MUCH more info.
userid: instoperatorid
pass: r4jr9XHG
I'm NOT sure if that password is for ALL KX-TGP600's or generated based on MAC/SN/Something else. Let me know.
I used the export operational values from the attached screen.
jholme004:
Oh wow...that did open up alot!
I'll compare this to your tonight and let you know what I find and any success.
Thanks again!
jholme004:
So I used word to do a "Compare Document" and accepted most of your changes...For example, I'm setting this up on Line 8, so I used your line 1 settings for line 8 and kept my line 1-4 as they were. Any config changes, I applied yours with the thinking I can use my Operational settings to revert back if something went sideways.
I still have the same issue - Connects to the Obi, places the call on SP1, the other side rings (and I hear ringing), but when the other side answers it disconnects. I'm pretty sure it's not a NAT or ALG issue, as the TGP and the Obi are on the same subnet, and the Obi can place calls through a POTS handset. My FreePBX can also place calls via a SIP account and through the Obi (via SP4).
I set the Obi to "Log Level 7", Sp1 (GV) and Sp3(TGP600) to "Log All Messages", and the TGP to the SIP Debug level 6. I've attached the log for the disconnected call. Unfortunately, I cannot see what is causing the disconnect, although I see where the TGP and the Obi both disconnect.
I've attached my operational values as well as the failed call logs.
I welcome any and all thoughts...
lrosenman:
I'm at a loss.
Here are my ITSP profile settings for my 1st GV Line. ICE and the Name are the 2 non default
The digit map is set for my GV911.com setup
Maybe the ICE parameters?
And the SP3 parameters for the TGP -> Obi.
Does that help?
192.168.200.94 is the KX-TGP600
My setup:
SP1 - My GV line
SP2 - My Wife's GV line
SP3 - Panasonic for GV1
SP4 - Panasonic for GV2
May not be the most efficient, but it's working
jholme004:
GOT IT!
The ONLY thing I changed was X_KeepAliveServerPort from the default 5060 to 5062 (I too am using SP3).
Thank you for all of your help!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page