Not able to hear the call receiver when I make outgoing calls using OBI110 and G

<< < (2/4) > >>

azrobert:
Quote from: krishsm on July 03, 2018, 10:58:49 pm

I can make and receive calls within USA, with no issues.
I can call international numbers, but can't hear the voice (note that

I use Circlenet for international calls. It will probably be cheaper for you than GV. Define Circlenet on SP2 then make the following configuration change using OBi Expert, so you won't need the **2 prefix.

Physical Interfaces -> Phone1 port ->
Add the following to the OutboundCallRoute:
{(011xx):sp2},

See:
http://www.circlenet.biz/

Edit:
I just read about the one way audio problem for the OBi1xx and FreePBX. The circumvention is to call your own GV number, enter 2 to make a new call and enter the number followed by a #. You also might be asked for a PIN. I know you have an OBI200, but it can't hurt to try.

TubeMan:
New OBI200 user. Incoming calls work fine. Outgoing calls to other VOIP phones work fine. Outgoing calls to AT&T and Verizon, the recipient can hear me, I cannot hear them.   Modem is a BGW210-700. What are my options?

Engineering:
@TubeMan: I am in exactly the same boat, so while I don't have a solution it seems to be a general problem with the new GV/SIP infrastructure.

Are you also running firmware 3.2.2 (Build: 5897EX)?

TubeMan:
Quote

Are you also running firmware 3.2.2 (Build: 5897EX)?

Yes.

NoStep:
Same here. Was on 5757, it self updated to 5897, but no change.

Navigation

[0] Message Index

[#] Next page

[*] Previous page