No ip address after installation

(1/3) > >>

TK_forum:
Hi,
I am new to this and looking for help from anyone who has experienced this.
I setup my obi110 few days ago and it work for a day or two. But I have to redo the whole setup twice already. I am not sure if the other devices in my house - Netflix, laptop, iPod touch could have taken the ip address used for the obi110, but when it happened, I cannot get ip address when I dial the ***, 1

Can anyone recommend a solution?

Thanks,
TK

oldtimercurt:
What do you get when you dial ***1?

OTC

TK_forum:
When it's bad, it would say ip address not available. I struggled on this the whole day yesterday, and this morning I set it up again and it work. I did noticed the ip address previously used (when it's working) is different from the current ip address. I was thinking could a fixed ip address solve this? And turn off DCHP.

RonR:
Quote from: TK_forum on August 29, 2011, 10:12:09 am

I setup my obi110 few days ago and it work for a day or two. But I have to redo the whole setup twice already.


Are you saying the OBi lost its entire configuration (reverted back to factory defaults?) twice?

LeftRight:
You can either use a static IP address or reserve the IP address on the router, and see if it gets better.

When OBi couldn't get/renew a IP address, how were your other devices? did they get IP address OK? would it help if you power cycle both your router and OBi (not factory reset the device)?

Navigation

[0] Message Index

[#] Next page