Red and Green Blinking Lights
Bver:
A couple of days ago I started getting the red and green blinking lights on my Obi200.
I'm also unable to get to the device web portal through its IP address.
What am I doing wrong?
Help please!
Bryan
RFC3261:
Quote from: Bver on July 04, 2018, 06:58:28 am
A couple of days ago I started getting the red and green blinking lights on my Obi200.
I'm also unable to get to the device web portal through its IP address.
What am I doing wrong?
You are likely not doing anything wrong. Alternating red/green means a firmware update failed in an especially bad way. You will have to follow the instructions starting at: https://www.obitalk.com/info/support/troubleshooting
Bver:
Hi and thanks for responding. I DID try to use these instructions at that link. However, I am unable to get into the Obi200 web interface. I got the IP address from my router but cannot get into the interface (using my Safari browser).
Bryan
drgeoff:
Quote from: Bver on July 05, 2018, 07:46:31 am
Hi and thanks for responding. I DID try to use these instructions at that link. However, I am unable to get into the Obi200 web interface. I got the IP address from my router but cannot get into the interface (using my Safari browser).
Bryan
Are you absolutely certain that you have an Obi200, not an Obi202? They are subtly different when it comes to getting to the local interface.
What is the IP address you are trying? If it does not begin with 192.168 or 10 then it is probably not the correct address.
What does the browser report when you try?
Bver:
Hi!
The label under the device shows it is an Obi200. My router reports the IP address as 192.168.0.011. Just noticed, however, that when I put this IP into my Safari browser it redirects(?) to 192.168.0.9, and doesn't connect!
That notwithstanding, I used instructions from someone else that directed me to try to RESET my Obi to factory defaults. So, I deleted the device on Obi dashboard, unplugged power and ethernet, (keep phone line connected), then waited for about five minutes. Then plugged in Power, waited for device to reset, but all I get is alternating Red/Green lights.
Bryan
Navigation
[0] Message Index
[#] Next page