Obi 200 + Obi110 for Line Port 911

<< < (2/2)

yehob150:
thank you for the instructions. I didn't get a chance to do it until now.

I followed all the instructions, now incoming calls on GV (SP1) do ring both Obi110 and Obi200.
Outgoing calls go through (GV) on Obi200 but not Obi110. (is this supposed to happen? if so then that is ok since I can just use Obi200 but want to make sure I didn't make a mistake)

The issue is that I'm not sure if 911 is working through the Obi110 line out port (into Ooma) since the test number that Ooma uses (611) just gives an error tone. In my previous setup with just Obi110 (back when GV worked with it) connected to Ooma via line out port 611 triggered the test call.

Did I do something wrong? or does another entry need to be made for 611 (in addition to 911)?

yehob150:
Quote from: azrobert on July 08, 2018, 08:35:31 am




I think you helped me a while back with the 611 passing through too in a different thread back when I was just using the Obi110 + Ooma. Can you guide me here?

azrobert:
OBi110

Voice Services -> SP1 Service -> X_InboundCallRoute:
{OBi200>611|911:li},{ph}

Physical Interfaces -> Phone Port ->
Add the following to the beginning to the OutboundCallRoute:
{611|911:li},

OBi200
Physical Interfaces -> Phone Port ->
Add the following to the beginning to the OutboundCallRoute:
{(611|911|0):sp4},

OBi110 and OBi200

Physical Interfaces -> Phone Port -> DigitMap

Add 611| before 911

yehob150:
Quote from: azrobert on August 02, 2018, 06:37:29 pm




Thank you, thank you, thank you.
You are awesome   ;D

Navigation

[0] Message Index

[*] Previous page