unable to register voip.ms

(1/2) > >>

sportflyer:
After installing obi200 from Obi100 . I can successfully register GV on SP1
However when I try to register  Voip.ms in SP2 using obitalk portal , I keep getting not configured or failed register 403 forbidden . What did I do wrong?

A_Friend:
Have you tried setting it up through the built-in UI on the box itself?

If it works with that, but doesn't work with the Portal, then you're not doing anything wrong.

As a minimum, all you need is:
1) a Name on ITSP B - General.  (This is for your benefit.)
2) the name of the voip.ms server you're using under ITSP B - SIP/ProxyServer and RegistrarServer
3) a few things under SP2:
  a) Enable it
  b) Choose ITSP B
  c) Your AuthUserName
  d) Your AuthPassword

Make sure you always "Submit" before leaving a page or rebooting.  Then, click on the Reboot button in the upper right.

sportflyer:
I will try. Do I need to stop Auto provisioning before manually configuring Voip.ms at device level?

drgeoff:
Quote from: sportflyer on July 12, 2018, 11:10:16 am

I will try. Do I need to stop Auto provisioning before manually configuring Voip.ms at device level?

Yes.

Mango:
Quote from: sportflyer on July 12, 2018, 10:31:07 am

However when I try to register  Voip.ms in SP2 using obitalk portal , I keep getting not configured or failed register 403 forbidden . What did I do wrong?


Note that your AuthUsername and AuthPassword is different from the email address and password you use to access the VoIP.ms website.

Navigation

[0] Message Index

[#] Next page