"Do not ring" on 1032/1062
Marc:
I've been looking for a way to set a single SP on "Do not ring." I have only found a way to set it for the entire device.
Anyone know how to set it for an SP and not the whole phone?
Thank you.
[Edit: Sorry about the quadruple post. I kept getting an error, "Couldn't get mail server response codes" when I submitted the post and assumed they weren't getting posted. I've deleted all the extra topics.]
N7AS:
If you do not want a specific sp not ring.
Go to
Voice Services > SPx
change
X_InboundCallRoute: {ph}
to
X_InboundCallRoute: {}
Marc:
Thanks for the reply.
I made the change, rebooted the phone... but for some reason it's still ringing.
azrobert:
Your inbound route is blank and not {}
Did you forget to enter it or did OBiTalk not accept it?
Blank will default to ph
Do you want to turn this blocking on/off without making config changes?
Marc:
I misunderstood the need for the brackets since ph was the default, not {ph}
I put {} in and it no longer rings but appears to be doing so by sending the ITSP some sort of signal that it's not there. That results in the ITSP ringing the failover line.
I guess I should explain what I'm trying to accomplish... I live in a rural area where internet and/or power outages are somewhat common. I have my primary VoIP lines ringing ring groups that consist of a local extension that I use and the extension on SP2. When the internet or power is down, the server won't be able to communicate with with the phones/ATAs and thus the failover for this one service will ring the home copper line. I maintain the copper line for emergencies.
My main number is google voice. Unfortunately GV doesn't have hunt groups. So this is the next best option... but only if I can figure out a way to silence the ring on this 1 SP.
Thanks.
Navigation
[0] Message Index
[#] Next page