trying to fix obi100

(1/2) > >>

nell:
hi my obi100 is not completing calls. it has 2886-naf7 firmware. so i connected the same service to obi200 on sp3. will this work? do i need to change any settings?  thank you nellie

bruceobi100:
Obi 100 series is dead for GV.  Put it in the electronics graveyard and enjoy the 200 series.  Better unit IMHO.

nell:
thank you  i was hoping to use the obi100 as a path to the obi200 sp3, that way, i will still have a phone connected to the obi 100   nell

azrobert:
You can do what you want. Any number dialed on the OBi100 will be routed out the OBi200's SP3. Speed dials must be modified to work. This setup uses the OBiTalk network to route calls between the boxes, therefore the OBiTalk network must be functioning. There is a more complex setup that doesn't use the OBiTalk network. I'll show you how if you want.

Use OBi Expert to make the following changes:

OBi200

Voice Services -> SP3 Service -> MaxSessions: 4
Voice Services -> SP3 Service -> X_InboundCallRoute:
ph,pp(200222222)

Voice Services -> OBiTalk Service -> InboundCallRoute:
{>0:ph},{200222222:sp3},{ph}

Replace 200222222 with the OBi number of the OBi100

OBi100

Physical Interfaces -> Phone Port -> OutboundCallRoute:
The 1st rule is: {([1-9]x?*(Mpli)):pp}
Change it to: {(<510111111*>(Mpli)):pp}

Replace 510111111 with OBi number of the OBi200

Physical Interfaces -> Phone Port -> PrimaryLine: SP1 Service

Voice Services -> OBiTalk Service -> InboundCallRoute: ph

Edit:

Dialing zero will ring the OBi200.

nell:
thank you azrobert.  this what i want to do. i'm hoping this will be an improvement. i will try it and get back to you
nellQuote from: azrobert on July 19, 2018, 06:44:01 am

You can do what you want. Any number dialed on the OBi100 will be routed out the OBi200's SP3. Speed dials will not work. This setup uses the OBiTalk network to route calls between the boxes, therefore the OBiTalk network must be functioning. There is a more complex setup that doesn't use the OBiTalk network. I'll show you how if you want.

Use OBi Expert to make the following changes:

OBi200

Voice Services -> SP3 Service -> MaxSessions: 4
Voice Services -> SP3 Service -> X_InboundCallRoute:
ph,pp(200222222)

Voice Services -> OBiTalk Service -> InboundCallRoute:
{>0:ph},{200222222:sp3},{ph}

Replace 200222222 with the OBi number of the OBi100

OBi100

Physical Interfaces -> Phone Port -> OutboundCallRoute:
The 1st rule is: {([1-9]x?*(Mpli)):pp}
Change it to: {(<510111111*>(Mpli)):pp}

Replace 510111111 with OBi number of the OBi200

Physical Interfaces -> Phone Port -> PrimaryLine: SP1 Service

Voice Services -> OBiTalk Service -> InboundCallRoute: ph

Edit:

Dialing zero will ring the OBi200.

Navigation

[0] Message Index

[#] Next page